Napoleon N750-0038 Built-In 700 Series & Built-In PRO Smoker Burner Wire

What Problem This Part Solves

A damaged, burned, loose, corroded, or broken smoker burner ignition wire can interrupt the electrical signal needed to ignite the smoker burner. This may cause weak or intermittent sparking, failure to ignite, or unreliable smoker burner operation.

Replacing the original wire with the Napoleon N750-0038 restores the factory electrical connection for the smoker burner ignition system.

Key Features

• Genuine Napoleon OEM replacement part
• Napoleon part number N750-0038
• Smoker burner ignition wire
• Part of the grill’s electronic ignition system
• Helps restore proper spark delivery to the smoker burner
• Factory-style connectors for correct fit
• Designed for select Built-In 700 Series and Built-In PRO grills

Compatibility / Fits Models

Fits select Napoleon grills, including:

Built-In 700 Series

• Select BIG32 models
• Select BIG38 models
• Select BIG44 models
• Select Built-In 700 Series configurations equipped with a smoker burner

Built-In PRO Series

• Select BIPRO500 models
• Select BIPRO665 models
• Select BIPRO825 models
• Select Built-In Prestige PRO configurations using smoker burner wire N750-0038

Fits most grills within this series—confirm model number before ordering.

Installation / Use Instructions

1. Disconnect electrical power and shut off the gas supply before servicing the grill.
2. Locate the existing smoker burner ignition wire and note the original routing and connector positions.
3. Remove the old wire and install the Napoleon N750-0038 using the same factory routing, keeping the wire away from hot surfaces and moving components.

Why Buy From Bar-B-Que.com

• Trusted grill experts since 1974
• Genuine replacement parts and premium accessories
• Fast nationwide shipping
• Family-owned with real product support

FAQ Section

Does this fit my grill?
The Napoleon N750-0038 fits select Built-In 700 Series and Built-In PRO grills equipped with the compatible smoker burner ignition system. Confirm your complete model and serial number before ordering.

What is this part made of?
The N750-0038 is an OEM insulated electrical ignition wire assembly with factory-style connectors designed for use inside compatible Napoleon grills.

How long should this part last?
Ignition wiring can last for many years, but heat, grease, moisture, abrasion, corrosion, or pinched wiring can shorten its service life. Replace it if the insulation or connectors become damaged or if troubleshooting confirms a wiring fault.

How do I install it?
Disconnect the grill from power and gas, remove the existing smoker burner ignition wire, and install the Napoleon N750-0038 following the original wire routing and connector locations.

Why choose this replacement part over others?
The Napoleon N750-0038 is a genuine OEM smoker burner wire designed for compatible Built-In 700 Series and Built-In PRO grills, helping maintain the correct connector fit, routing, and ignition-system compatibility.